Pressed profile comes out on the output table, where it is accepted by system of pullers, that enables through its construction a continual conducting of profiles along the exit and cooling table during pressing. System for intensive cooling of profiles is located under and above the exit table and along the transport table of a double length. Its basic purpose is cooling by a directed air stream with possibility of regulating the cooling intensity and achieving of an optimal cooling degree for various aluminium alloys. If a higher degree of cooling is required, cooling with water is used, or so called water wave, where significantly greater speeds are achieved, which is of a particular significance at pressing of harder alloys. Cooling table is divided into several temperature zones and enables lateral moving of profiles pressed in regard to table axis by the system of endless belt, which eliminates possibility of profile’s mechanical damages in relation to the traditional walking beam mode/way of moving. Mechanical equation/alignment of profiles is achieved at the tensioner, which is completely automatized and handled by a single operator with usage and help of video monitoring.